Technical data：

• Working width / Gauge：

3454 mm = 136″

E18, E22, E24, E28

• Knock-over comb bar distance：

2–12 mm, continuously adjust able. Central trick plate distance readjustment

• Bars / knitting elements：

Six ground guide bars, one Piezo Jacquard guide bar (split execution);

GB3, GB4, JB5 and JB6 stitch forming on both needle bars.

Two individual latch needle bars, two knock-over comb bars, two stitch comb bars

• Warp beam support：

7 × 812 mm = 32″ (free-standing)

• GrandStar®(GrandStar COMMAND SYSTEM)

Operator interface to configure, control and adjust the electronic functionality of the machine

• Yarn Iet-off device

For each completely mounted warp beam position: one electronically controlled yarn Iet-off drive

• Fabric take-up

Electronically regulated fabric take-up, driven by geared motor, consisting of four rollers.

• Batching device

Separate rolling device

• Pattern drive

Electronic guide bar drive EL, all guide bars shog up to 150 mm

• Electrical equipment

Speed-regulated drive, total connected load of the machine: 7.5 KW

Voltage: 380V±10% three-phase power supply, main power cord requirements: not less than 4m㎡ three-phase four-core power cord, ground wire not less than 6m㎡

• Oil supply

Heating and cooling by means of circulating air heat exchanger, filter with dirt-monitoring system

• Equipment working conditions

Temperature 25℃±3℃, humidity 65%±10%

Floor pressure: 2000-4000KG/㎡

0